Highcross products

The digital temperature sensor module ECM-DTS16D is designed to receive temperature data from digital temperature sensors. 1-Wire Bus is used for sensors connection. The device supports «parasite power» of the sensors as well as powering from Vdd terminals. The control, data exchange and configuration are all handled via TCP/IP protocol.

The device can be used with up to 8 digital sensors with singleended connection when they are connected directly to channel. Up to 16 temperature sensors can be connected when they are combined to a bus which is connected to channel #1. The detection of sensor’s addresses and assigning them to channels is performed via web-interface.

The Highcross ECM-UTM4D is an electronic universal 3-channel thermostat module designed to control of heating or cooling systems. The module has three built-in thermostats, three power relays, four analog inputs for temperature sensors, three pairs of digital inputs for priority dry-contact control from window-contact or etc.

All relay outputs are normally open and are disconnected when the power is off. The control, data exchange and configuration are all handled via TCP/IP protocol. The module is designed to be installed on a standard 35 mm DIN rail.

The multisensor is designed to measure and transmit information from digital sensors of air temperature and humidity, illumination, pressure and air quality.

The device uses a digital bus HCBus and connects to EBM-BUS2D controller that communicates with external controllers via Ethernet.

See section HCBus Modules.